Constellation Instrument & Control Technician Interview Questions | Glassdoor

Constellation Instrument & Control Technician Interview Questions

1 Interview Review

Experience

Experience
100%
0%
0%

Getting an Interview

Getting an Interview
100%

Difficulty

1.0
Average

Difficulty

Hard
Average
Easy

1 Candidate Interview ReviewBack to all Interviews

Filter

Sort: PopularDateDifficulty

Filter

Sort: PopularDateDifficulty

 

Instrument & Control Technician Interview

Anonymous Employee in Lusby, MD
Accepted Offer
Positive Experience
Easy Interview

Application

I applied through a recruiter. The process took 1 day. I interviewed at Constellation (Lusby, MD) in November 2011.

Interview

Got a call from a recruiter. The interview was set up for a week later. I had to take the EEI Tech test (easy), They grade it immediately and if you pass you get an interview. Then I had an interview with 2 people (technical questions asked during interview were easy), they were very friendly but the male interviewer stares at you. After the test and interview had a sit down with an HR rep. I got an offer within a week. I still have to do drug test, psych eval, and background screening.

Interview Questions

  • why would we use a current loop in our equipment instead of a voltage loop?   1 Answer
  • if you have a pump in a run of piping a dp pressure readouts coming off the piping, one 3 floors above, one in line with the pump, and one 3 levels below, which is most accurate? Will the one above read higher, lower, or the same? What about the one below?   2 Answers

Negotiation

I was happy with the initial offer because it was substantially higher than what I was making. They pay well.

Don't Miss Out On a Job You Love
Upload a resume to easily apply to jobs from anywhere. It's simple to set up.