Texas Instruments Characterization Engineer Interview Questions | Glassdoor

Texas Instruments Characterization Engineer Interview Questions

2 Interview Reviews

Experience

Experience
100%
0%
0%

Getting an Interview

Getting an Interview
100%

Difficulty

3.5
Average

Difficulty

Hard
Average
Easy

2 Candidate Interview Reviews Back to all Interviews

Filter

Sort: Popular Date Difficulty

Filter

Sort: Popular Date Difficulty
  1. Helpful (1)  

    Test and Characterization Engineer Interview

    Anonymous Employee in Tucson, AZ
    Accepted Offer
    Positive Experience
    Average Interview

    Application

    The process took 1 day. I interviewed at Texas Instruments (Tucson, AZ) in September 2010.

    Interview

    I had a phone interview which was about my resume. An onsite interview was scheduled in the phone interview itself. Had 7 rounds of 1:1 interviews in the on site interview. Interviewers were very friendly and helped me if I got stuck at some question. IT was a good experience for me.

    Interview Questions

    • What would be the typical feedback resistances values that you would use in OPAMP design and why?   Answer Question

    Negotiation

    They gave me a very good offer. So did not negotiate.


  2.  

    Analog Test and Characterization Engineer Interview

    Anonymous Employee in Bengaluru (India)
    Accepted Offer
    Positive Experience
    Difficult Interview

    Application

    I applied through an employee referral. I interviewed at Texas Instruments (Bengaluru (India)) in April 2014.

    Interview

    The Interview process is quite technical. There are two technical rounds and one HR rounds. The technical round is mostly on basic RC circuits, opamps, frequency response...etc. They will test basic fundamental knowledge.

    Interview Questions

    • RC circuits, OPAMPS, frequency response and final year project.   Answer Question

Don't Miss Out On a Job You Love
Upload a resume to easily apply to jobs from anywhere. It's simple to set up.